Question:
I'm 5 months out and still feeling tender around port site..Am I alone or is anyone
feeling this also? The dr. said that it was scar tissue....I'm still not sure that it is....Hurts more when I lay on that side.. — rhammgag (posted on November 8, 2007)
November 8, 2007
Hi,I'm 7 mo out and still have some tenderness. I asked my M.D. he said
this is normal and my always have some tenderness because it is sewen into
the muscle. Also the more weight you loose when you lay on youre tummy like
I do you will feel it more. I hope this helps somewhat. Diane
— dgelrn95
November 8, 2007
I am 5 months out also - but do not have tenderness. Recently at the gym
while using the Cybex machine where you twist with weights from side to
side - I could feel it pulling when I turned to the left - but not to the
right. I was concerned that I might be tearing something loose. Dr said
not to worry - that it is sewn into the muscle in those 4 holes in the
band. He said he has seen some work by some of the Mexico Dr's and they
have only sewn it into one of those holes (the holes are at 12 3 6 and 9
around the band). So unless you had yours done in Mexico - most likely
everything will be fine. Also did you recently have a fill - sometimes -
it will be a little tender after a fill because of the inflammation. How
much have you lost? I have lost 42 pds. My 5 months out will be in 9
days. Best Wishes - CJ
— CDJ
November 8, 2007
Well, I hate to tell ya, but I'm one and a half years out and still feel it
a bit. My P.A. said that it's probably because when it was sewn into the
muscle, the Dr. might have also grabbed a nerve. It's not bad, just
slightly annoying esp. when I exercise a lot, but I think I'm just gonna
have to get used to it. It's never debilitating or anything like that. My
weight loss far outweighs (no pun intended) the slight annoyance. 5 more
pounds and I'll reach the 100 pound mark! Good luck to you!
— Debra R.
November 11, 2007
If you don't think it is scar tissue, what do you think it is?
— mrsidknee
Click Here to Return